Warwick X7220 Bedienungsanleitung Seite 1

WARWICK WIRELESSWARWICK WIRELESSWARWICK WIRELESSWARWICK WIRELESS LIMITEDLIMITEDLIMITEDLIMITED X7220 DUAL REDUNDANT BASE STATION

6.2 Service Port Menue The Service Port Menu is displayed by connecting a PC configured at the Baud Rate set previously (Factory set at 9600) and

Address Mode Not used TX Address Not used RX Address Not used Restore Defaults Set Factory Defaults. Exit without Save Re

7.0 RADIO TRANSMISSION 7.1 Radio Frequency Hex RF Tx RF RxRF Channel Channel Frequency Frequency SW5 SW4 SW3 SW2 SW1 02H

7.3 Radio Propagation When installing a X7220 Radio Modem there are a number of factors that should be considered as they will affect the performan

8.4 Radio Path The radio path can be tested by configuring the transmitting modem to the Repeater Mode. Exit the configuration menu and transm

INDEX 1.0 FEATURES 2.0 SPECIFICATION 3.0 INTERFACES 3.1 Communications Port 9 Way D Connector 3.2 Service Port 9 Way D Connector 3.3 LED In

1.0 FEATURES • Operates on international licensed and licence free radio bands. • RF Bands: 147MHz to 174MHz VHF 400MHz to 500MHz UHF 868M

2.0 SPECIFICATION ABSOLUTE MAXIMUM RATINGS Storage Temperature ... -30 to +85 Celsius Operating Temperature .

3.0 INTERFACES 3.1 Communication Port 9 Way D Type Connector RS232/RS485 1 ALARM CONTACT OUTPUT 6 ALARM CONTACT OUTPUT 2 RS232 RD R

3.3 LED Indicators Eight LED’s on the front of the modem indicate the following states: Transmit Data 1 Green On when modem 1 is transmitti

not then the data is stored in the buffer until the channel becomes free. If it is free then a preamble message will be transmitted so that the rece

If a second PC is not available simply power up the second modem. Configure the modem connected to the PC in the repeater mode with the address mode

Parity Enable Parity Odd/Even Odd, Even or No Parity can be selected . RF Channel On of 17 RF Frequency can be selected. Key T